Repair kit
Products
- HumiStat mixer
- Mass flow controllers
- Samples, substrates and targets
- Ceramic oxide powders
- ProboStat
- ProboStat Systems
- ProboStat Accessories
- Measurement Software
- Impedance
- Seebeck and resistance measurement system
- PEM sample holder
- Atmosphere Control
- Coulometric Titration
- Heating mantle 600ºC
- Furnace 1200ºC
- Furnace 1600ºC
- Data logger
- Low flow Oxygen sensor
- Other Products
Feedthrough replacement kit is used for on-site replacement of electrical mini-contact feedthroughs.
It consists of:
- Selection of preassembled feedthroughs (male mini-contact, PEEK insulator and compensation wire)
- Bar and flat steel tool for hammering out old feedthrough
- Bar for hammering in new feedthrough
- Cell support ring
- Instruction sheets
In addition you need: Solder iron, tong, hammer.
